- Add per-channel amplifier (0-100, 1.0x to 10.0x) applied to intensity
before limiter gates strength
- Fix heat map scaling: use LimitScaleA/B (valA/DesiredA ratio) instead
of valA/200 — was capping colors at green, never reaching orange
- Scale heat map intensity by limiter ratio so colors reflect actual
output after limiter
- Remove dead LastIntensityA/B field (replaced by heat map scaling)
- Amp trackbars: 0=1.0x, 100=10.0x, integer value labels
- Close button quits app instead of hiding to tray
- Swap checkbox moved up to the Connect/device line
- Limiter values shown as separate labels (plain, 32px wide for 3 digits)
- Trackbar keyboard: Up/PageUp/Home = increase, Down/PageDown/End = decrease
- Fix Lim B trackbar clipping (moved down to avoid overlap with Lim A)
- Separate Lim A / Lim B trackbars (0-200, default 30 each)
- Separate Scale A / Scale B checkboxes (clamp vs scale per channel)
- State.SetLimitA/SetLimitB with independent LimitModeA/LimitModeB
- ConsumeTick applies per-channel limit and mode
- Send gauges now show waveform intensity (0-100) not strength ceiling
- State.LastIntensityA/B tracks average intensity per tick
- Zero when no pattern/stream active (was 25 due to IntensityOff 101 sentinel)
- Recv gauges unchanged (device-reported strength 0-200)
- Four gauges: Send A/B (commanded) and Recv A/B (device-reported)
- State.LastSentA/B tracks what would be sent after limiting
- ConsumeTick always runs; only SendB0 gated on IsConnected
- Stream queues drain correctly in dev mode (no box)
- Tray icon hot state works without BLE connected
- Removed strength text label, widened form to 420x360
- Renamed from CoyoteBridge to Substation (namespace, classes, UI)
- BLE connection via WinRT with graceful disconnect handling
- WebSocket server (127.0.0.1:8765) with single-client, push events
for BLE connect/disconnect transitions
- Operator strength limiter (clamp/scale modes, default 30)
- Tray icon with 3 states: neutral/active/hot (runtime-drawn voltage glyph)
- A/B strength gauges, hide-on-minimise to tray
- Music mode: MP3 decode + FFT analysis (NAudio + FftSharp), rhythm→ch A,
melody→ch B, pre-analyzed with synced audio playback
- Test/Stop All work without BLE connected (dev mode)
- WS device-driving commands error when BLE not connected; ping/status/
connect always work
- TreatWarningsAsErrors, LangVersion=latest
- .gitignore, README with full API docs + attribution
mute